Venting Cap Plugs - UVCP-SH SERIES
Ultrabake™ Venting Cap Plugs are designed to mask plain and threaded studs or holes; there is a small nipple on the top of the mask which can easily be punctured or removed to form the small vent. The masks then mask off the hole or stud and allow trapped air to escape from inside the cap through the vent.
How the product is used
When used as a cap the cap is applied by being pushed over the stud, as the cap is pushed onto the stud the trapped air will escape from the inside of the cap allowing the operator to push the cap down into position. It can then be removed by being pulled off. When used as a plug the plug can be pushed into the hole and air will escape from the plug as the plug is pushed into position.
Powder coating, E-coating, Plating, Anodizing, Spray painting
Maximum temperature 600°F (315°C)
Items should be stored in dry conditions at an ambient temperature of between 55°F (13°C) and 85°F (30°C). It is important to rotate stock and use the product in the order that it is received.
|Lp.||Kod||Std. kolor||A (mm)||B (mm)||C (mm)||Ilość w opakowaniu||Min. Ilość|
Legenda: N/A – niedostępne